Classroom Procedures
Mrs. Mili Rengifo
Find this document at: www.mili.myclassupdates.com
Entering the room
Wait in line outside the classroom if
the door is closed and enter quietly when the teacher opens the door.
Sit in your assigned seat ready for work.
Keep all your belongings
under your worktable, including the water bottles.
Keep all the electronics that are not allowed in class inside
your bookbag.
Do Bell-Ringer assignment.
If you are tardy
Go straight to the office
to get an ADMIT
Go to your class and enter quietly.
Hand in your ADMIT to the teacher and wait until it is signed and recorded
in the gradebook.
Sit in your assigned seat, take out your materials and begin the assignment.
Getting your attention
Teacher will ring a bell
and wait for everybody to be quiet.
You will stop the activity you are doing,
turn to face the teacher and get ready for instruction.
Paper heading
If you are submitting papers online or hard
copies, add name, grade, period and title to all assignments.
Place it on top right side of paper on all homework and
assignments.
After an absence
You are
responsible for making-up the missing work.
Retrieve or print any handout and/or ask the teacher. Remember: It is your
responsibility to ask for work if you were absent.
Make up classwork
and turn it in as soon as possible.
Handing in Homework, Extra-credit assignments or papers
Put it on top of your table
as soon as you come into class. The teacher (or designee) will walk around and collect it. Engineering notebooks
and material related to teamwork should remain in your box or in the designated location.
If you are working
in a technology/robotics project
Wear your personal
safety glasses.
Pick up team materials 10’ before the bell, and
personal materials 1’ before the bell.
If you finish early...
work on unfinished assignments, take charge of the engineering
notebook.
start homework.
read and complete reading logs.
Classroom discussions
Raise your hand and wait
to be allowed to participate.
Make all questions and comments relevant to current discussion.
If your question is off
topic, write it down on your engineering notebook and ask later.
Moving around the room/restroom breaks/ drinking
water
Raise your hand and wait in silence.
If you get a pass to leave the class, you must give it back. Do not
keep it.
Going to Lunch (if applicable)
Students will be instructed when and where to line up.
You will form one straight
line (one student behind the other).
After lunch, teacher will pick you up.
Walk back following the same procedures.
If teacher allows the class
to go to the restroom before going back to class, always observe the same procedures: straight line and one behind
the other.
Class Dismissal
Wait until teacher officially dismisses the class. Teacher or designee will open the
door for the class to leave.
Start packing group and personal belongings when you are instructed to do so: Team materials
10’ before the bell, and personal materials 1’ before the bell.
Special Procedures: These will be introduced
as needed:
Project procedures and safety precautions
Lost & Found
Library/Computers
Special Guests
Progress reports
Working cooperatively
Fire Drill/Tornado drill/Lockdown
Assemblies
Substitute Teacher
Let’s have an awesome year
♥
GO ROCKBOTS!